Meade Image Processing Especificaciones descargar pdf (Pagina 14)

4 AUTOSTAR CCD PHOTOMETRY

The AutoStar Envisage window will then open (Fig. 2-2). After a

few moments, if there are problems and the camera image doesn't

show up, check the USB connection to the DSI camera. You

should use a powered USB 2.0 interface, even though the DSI

camera will work marginally with USB 1.0. If problems persist, try

another USB cable. Note: A maximum length of 12 to 16 feet (3.5

to 5 meters) is recommended for the USB 2.0 cable connection to

the DSI camera.

Figure 2-2. AutoStar Envisage Screen -- Selecting Settings.

(Camera Not Connected or Inoperative).

Figure 2-2 shows the AutoStar Envisage default window, the one

that displays when the camera is not recognized (not connected or

has a problem). This is easily identified by the "Add" and

"Remove" buttons at the upper left. When the camera is connected

and all is working, those are replaced by the "Gain" and "Offset"

sliders. (Also note that the window showing the camera image is

blank.) It may be necessary to re-connect the USB cable and

camera to a specific USB port, in order for the device to be

recognized.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 127 128

Sin comentarios

Meade Image Processing Especificaciones Pagina 14